Sony PCS-1 Operating Instructions Manual page 143

To connect to a computer via a hub
Connect the Communication Terminal to a computer using the UTP straight
cable.
Computer
to LAN connector
To configure the Communication Terminal
Open Page 2 of the General Setup menu, and enter the IP address of the
computer in which the NetMeeting application is installed in the "T.120 PC
Address" text box. (See page 49.)
To call a remote party to conduct a T.120 data conference
Set "T.120 Data" to "On" in Page 2 of the Dial Setup menu. (See page 45.)
When you receive a call from a remote party to conduct a T.120
data conference
Set "T.120 Data" to "On" in Page 2 of the Answer Setup menu. (See page 48.)
Note
It is recommended that you set "Audio Mode" to "G.728" in the Dial Setup and Answer
Setup menus.
To connect to a remote party using NetMeeting
Before connecting, install the NetMeeting application in your computer.
1
Double-click the NetMeeting icon, or click "NetMeeting" from the Start
menu on the computer's window.
NetMeeting starts.
2
Set the Communication Terminal to communication mode.
Check that the "T.120" indicator is displayed on the monitor screen.
Conducting a Data Conference Using NetMeeting – T.120 Data Conference
Hub
UTP straight cable (not supplied)
TERMINAL VISCA OUT
AUDIO OUT AUX1– VIDEO IN –AUX2 AUDIO IN CAMERA UNIT MIC
(PLUG IN POWER)
1 2
(MIXED)
VIDEO OUT 100BASE-TX
AUX MAIN– MONITOR– SUB 10BASE-T
RGB OUT DSB
IR OUT
1 2
to 100BASE-TX/
10BASE-T
ISDN UNIT WHITE
BOARD
DC 19.5V
143