Turning the System On/Off
This section describes how to turn on or off the Communication Terminal.
Turning On
1
Turn on the TV monitor.
If the IR repeater is installed in the TV monitor, set the TV monitor to standby
mode. The TV monitor will turn on simultaneously when the Communication
Terminal is turned on.
2
Turn on the power of any other equipment to be used for the
videoconference.
3
Set the power switch on the right side of the Communication Terminal to
the on position (
The Communication Terminal turns on. Three indicators on the front of the
Communication Terminal and the POWER indicator on the camera light, then
only the POWER indicators on both units remain on in green. The launcher
menu will appear on the monitor screen and the picture shot by the local camera
will also appear in the launcher menu.
Launcher menu
).
@
POWER indicators
(Light in green.)
Connect
Phone Book
Dial
Menu
Press to show help
IP:0.0.0.0
Video:Main
Power switch
Angle Adj.
ISDN:012345678912
Audio:MIC(INT)+AUX
Turning the System On/Off
29