Using The Communication Transducer (Cte) - Sony PCS-G70 Operating Instructions Manual

Using the Communication Transducer
(CTE)
The CTE Communication Transducer is an integrated system equipped with
uni-directional microphones and omni-directional acoustic speaker. The unit is
enabled to pick up clear voice with minimum background noise from all
directions and to emit clear sound equally in all directions.
To connect the CTE-600 Communication Transducer
CTE-600
to an input/output
connector
TERMINAL VISCA OUT
MCU VIDEO OUT AUDIO OUT AUDIO IN
(MIXED) AUX LINE MIC
(PLUG IN POWER)
1 2
1 2 3 4 5
DC 19.5V 1 2
IR OUT EC-MIC
AUX CONTROL
1 2 CTRL-S 1 2
AUX MONITOR
VIDEO OUT
To use the Communication Transducer (CTE)
• Set "CTE" on page 1 of the Audio Setup menu to "LINE". (page 50)
• Set the SYSTEM SELECT switch at the bottom of the Communication
Transducer to "PCS".
For detailed information on the Communication Transducer, refer to the
Operating Instructions that come with the Communication Transducer.
to an input/output
connector
Cable
(supplied
with the
CTE-600)
to LINE
OUT
Cable (not supplied)
MAIN SUB
CAMERA AUX IN CAMERA AUX IN
to AUDIO
WHITE 100BASE-TX/
BOARD 10BASE-T
RGB OUT DSB
ISDN UNIT
IN
to AUDIO OUT

Using the Communication Transducer (CTE)

Interface box
(supplied with the CTE-600)
to DC 6V
to LINE
IN
AC adaptor (supplied
with the CTE-600)
Cable (not supplied)
to a wall
outlet
131