Sony PCS-1 Operating Instructions Manual page 250

Message
LAN configuration error. Unauthorized NAT
address is specified. Check the NAT address.
LAN configuration error. Different address
from NAT machines is specified. Check the
NAT address.
LAN configuration error. Connection is not
complete as the port number overlaps.
LAN configuration error. Connection is not
complete as an invalid port number is
specified.
Line is busy. Try to dial again later.
Local number is not set correctly in the
ISDN Setup menu. Set it correctly. Line
connected with 1B (64K).
Local number setting for ISDN
configuration may not be correct in the
remote party. Line connected with 1B (64K).
H.221 negotiation timeout. Restart the
system and connect again.
Dialing the same address is invalid.
The ISDN lines fully occupied. Check
Number of Lines in the Multipoint Setup
menu, or check whether the ISDN cable is
disconnected.
Regarded as a secondary terminal as the
number of lines for ISDN configuration is
different.
Regarded as a secondary terminal as Far End
Camera Control is set to Off.
Check the line interface or the IP address is
set correctly.
Dial setup error. No prefix number is
entered.
Dial setup error. No prefix number for LAN
is entered.
LAN configuration error. PPPoE is set to
On. Check the PPPoE User Name and
Password.
LAN configuration error. IP Precedence
exceeds the maximum value.
LAN configuration error. Diffserve exceeds
the maximum value.
250
On Screen Messages
Meaning
The set NAT address cannot be used. Enter the
correct NAT address in the LAN Setup menu.
Enter the correct NAT address in the LAN Setup
menu.
Check the TCP and UDP port numbers in the LAN
Setup menu.
Check the TCP and UDP port numbers in the LAN
Setup menu.
Connection has filed as the line is busy. Try to dial
again later.
ISDN line has been connected with 1B (64K)
channel. Set the local numbers correctly in the
ISDN Setup menu.
ISDN line has been connected with 1B (64K)
channel. The local numbers may not be correctly
set in the remote party.
Turn off your system, turn it on and try to dial
again.
You are calling the same party.
Check the number of ISDN lines is correctly set in
the Multipoint Setup menu, or check the ISDN
cable connection.
Some functions may be limited as your system is
regarded as secondary terminal.
Some functions may be limited as your system is
regarded as secondary terminal.
Select the line interface correctly or enter the
correct IP address.
The prefix is not registered in the Dial Setup menu.
The prefix is not registered in the Dial Setup menu.
PPPoE is set for LAN connection. Configuration of
the user name and password is required.
Set the IP Precedence value between 0 and 7 in the
LAN Setup menu.
Set the Diffserve value between 0 and 64 in the
LAN Setup menu.