Table of Contents
Advertisement
11
Attach the condenser holder.
Attach a condenser holder to the substage. (Remove or
attach the condenser holder after detaching the stage.)
Tool: Hex wrench (3 mm across flats)
Hook the half dovetail of the condenser holder onto the
half dovetail groove of the lower substage and push it
against the reference surface. Then, tighten the fixing
screw on the top of the substage.
12
Attach the stage.
12.1
For standard stage
(1)
Turn the coarse focus knob until the substage is
brought to the lowermost position.
(2)
Loosen the stage clamp screw on the front of the
stage.
(3)
Align the stage with the round dovetail of the
substage and secure it in place with the stage clamp
screw.
12.2
For rotatable ceramic coated stage
Tools:
Hex driver (2 mm across flats)
Centering tool: Ball-point hex drivers provided with
the product (x2)
(1)
Sufficiently loosen the two right and left centering
screws on the back of the substage and the stage
positioning screw on the front of the stage using a
hex driver.
(2)
Attach by engaging the round dovetail at the bottom
of the stage with the round dovetail of the substage.
(3)
Center the stage and then tighten the stage
positioning screw.
(See Chapter 3, "3 Bringing the Target into the
Optical Path (Horizontal Stage Movement, Rotation)
- ■Centering the rotatable ceramic coated stage" in
the "Operation")
When removing the stage
When removing the stage, loosen the stage centering
screws (x2) and stage positioning screw.
Chapter 1
Assembly
Stage
clamp screw
Stage centering screws
(on both sides)
Securing the rotatable ceramic coated stage
12
Condenser holder
fixing screw
Half dovetail
groove
Half dovetail
Attaching the condenser holder
Securing the standard stage
Stage positioning
screw
N
ND
3
8
OU T
IN
Hide quick links:
Advertisement
Table of Contents
