Seagull Models Funfly 3D Assembly Manual page 5

3x35mm.
2) Position the control horn on the bottom of
the aileron. You will see pre-drill hole 3mm for
the horn mounting screw on the aileron.
3mm.
3) Place epoxy into hole. This will harden the
threads and prevent the crews from pulling
loose.
4) Thread a control horn end with aluminum
washer, lock nut until the top edge of the end is
18mm from the vase of the horn as shown.
CONTROL HORN
M3 SCREW.
Epoxy.
Wing
.
M3 LOCK NUT
Wing
.
18mm
www.seagullmodels.com
2 sets.
.
ALUMINUM WASHER
.
ALUMINUM WASHER
.
Epoxy
Aileron control horn.
INSTALL ELEVATOR CONTROL HORN.
Install the elevator control horn using the
same method as same as the aileron control
horns.
3x35mm.
3mm.
CONTROL HORN M3
Aluminum Washer.
Horizontal
Stabilizer.
Aluminum Washer.
2 sets.
.
Epoxy
Elevator.
.
M3 LOCK NUT
5