Seagull Models Funfly 3D Assembly Manual page 21

www.seagullmodels.com
110mm.
Aileron pushrod.
M3 clevis. M3 lock nut.
M3 lock nut.
140mm.
INSTALLATION TAILWHEEL.
Elevator pushrod.
Rudder pushrod.
M2 x 12mm.
AILERON PUSHROD HORN INSTALLATION.
1) Locate the pre-drilled hole in the bottom
of the rudder. This is the hole for the vertical
shaft of the tailwheel assembly.
110mm.
Epoxy.
M3 clevis.
M3 lock nut.
140mm.
2) Temporarily mount the tailwheel
assembly to the bottom of rudder. Do not glue
at this time. Slide the nylon tailwheel support
brackets to be evenly spaced along the
tailwheel wire.
3) Mark where you drill the two locations
for the tailwheel support.
21