Barco R9002321 Owner's Manual page 23

Table of Contents

Use the supplied power cord to connect your projector to the wall outlet. Plug

the female power connector into the male connector at the front of the projector.

The projector is switched ON and OFF using the power (mains) switch ON/OFF.

Pressed : ON

Not pressed : OFF

The projector can start now in the 'operational mode' (image displayed) or in the

'stand by mode', depending on the position of the 'power up' dip switch on the

controller unit. This DIP switch is set during installation by a qualified technician.

If you want to change this start up mode, call a qualified technician.

Stand by indication lamp :

no light up : projector in operational mode

red : projector is in stand by.

LEDs on the front plate of the projector

3-2

See installation instructions before

V NOM 120/230 Volt

connecting to the supply

I MAX

FREQ 60/50 Hz

OFF ON

R5975059 BARCOVISION 708 MULTIMEDIA 200498