IBM IntelliStation 6866 Hardware Maintenance Manual page 70

Diagnostic Error Code
170-198-XXX Voltage Sensor(s) test aborted
170-199-XXX Voltage Sensor(s) test failed, cause unknown
170-250-XXX
170-251-XXX Voltage Sensor(s) Voltage limit error
170-254-XXX Voltage Sensor(s) Voltage Regulator Module
error
175-000-XXX Thermal Sensor(s) Test Passed
175-0XX-XXX Thermal Sensor(s) failure
175-195-XXX Thermal Sensor(s) Test aborted by user
175-196-XXX Thermal Sensor(s) test halt, error threshold
exceeded
175-197-XXX Thermal Sensor(s) test warning
175-198-XXX Thermal Sensor(s) test aborted
175-199-XXX Thermal Sensor(s) test failed, cause
unknown
175-250-XXX
175-251-XXX Thermal Sensor(s) limit error
185-000-XXX Asset Security Test Passed
185-XXX-XXX Asset Security failure
185-278-XXX Asset Security Chassis Intrusion
62
IBM IntelliStation Type 6866: Hardware Maintenance Manual
FRU/Action
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to the "Undetermined problems" section
1. Go to the "Undetermined problems" section
2. Flash the system and re-test
3. Replace component under function test
1. Power supply
2. System board
1. Voltage Regulator Module (VRM)
2. Microprocessor
3. System board
1.
No action
1. Flash system
2. System board
1. Information
2. Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled
2. Re-run test
3. Component that is called out in warning statement
4. Component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test
3. Go to "Undetermined problems" section
1.
Go to the "Undetermined problems" section
2. Flash the system and re-test
3. Replace component under function test
1. Check fans
2. Check Power supply
3. Microprocessor
4. System board
1.
No action
1. Flash system
2. System board
1. Assure Asset Security Enabled
2. C2 Cover Switch
3. System board