Table of Contents
Advertisement
Diagnostic Error Code
006-196-XXX Diskette interface test halt, error threshold
exceeded
006-197-XXX Diskette interface test warning
006-198-XXX Diskette interface test aborted
006-199-XXX Diskette interface test failed, cause unknown 1.
006-25X-XXX Diskette interface Error
011-000-XXX Serial port Interface Test Passed
011-001-XXX Serial port Presence
011-002-XXX
011-003-XXX Serial port Timeout/Parity error
011-013-XXX
011-014-XXX Serial port Control Signal/Loopback test
failure
011-015-XXX Serial port External Loopback failure
011-027-XXX Serial port Configuration/Setup error
011-03X-XXX
011-04X-XXX Serial port failure
011-195-XXX Serial port Test aborted by user
011-196-XXX Serial port test halt, error threshold exceeded 1.
011-197-XXX Serial port test warning
FRU/Action
1.
Press F3 to review the log file
2.
Re-start the test to reset the log file
1.
If a component is called out, make sure it is
connected and/or enabled
2.
Re-run test
3.
Component that is called out in warning statement
4.
Component under test
1.
If a component is called out, make sure it is
connected and/or enabled
2.
Flash the system and re-test
3.
Go to the "Undetermined problems" section
Go to the "Undetermined problems" section
2.
Flash the system and re-test
3.
Replace component under function test
1.
Diskette drive cable
2.
Diskette drive
3.
System board
1.
No action
1.
Remove external serial device, if present
2.
Run setup, enable port
3.
System board
1.
System board
1.
System board
1.
Wrap plug
2.
System board
1.
Run Setup, enable port
2.
Flash the system
3.
System board
1.
System board
1.
Information
2.
Re-start the test, if necessary
Press F3 to review the log file
2.
Re-start the test to reset the log file
1.
Make sure the component that is called out is
connected and/or enabled
2.
Re-run test
3.
Component that is called out in warning statement
4.
Component under test
53
Symptom-to-FRU index
Advertisement
Chapters
Table of Contents
