Flash Over Lan (Update Post/Bios Over Network); Wake On Lan - IBM IntelliStation 6866 Hardware Maintenance Manual

Table of Contents

Advertisement

Flash over LAN (update POST/BIOS over network)

Wake on LAN

Note: For local Flash (BIOS/VPD) update, see "Flash (BIOS/VPD) update
procedure" on page 93.
This setting is used to enable or disable the Flash over LAN feature. When the feature
is enabled, the system programs, in the computer, can be updated remotely from a
network server. If the administrator password is set in the computer, it does not have
to be entered by the server.
To access the Flash over LAN setting, use the following procedure.
1.
Start the Configuration/Setup Utility program. See "Setup Utility program" on
page 5.
2.
Select System Security.
3.
Select POST/BIOS Update from the Configuration/Setup Utility program menu.
4.
To enable Flash over LAN, select Enabled. To disable Flash over LAN, select
Disabled.
5.
Press Esc twice to return to the Configuration/Setup Utility program menu.
6.
Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
7.
To exit from the Configuration/Setup Utility program, press Esc and follow the
instructions on the screen.
This setting is used to enable or disable the IBM-developed Wake on LAN feature.
This feature makes it possible for the computer to be turned on remotely by a network
server. Remote network management software must be used in conjunction with this
feature.
To access the Wake on LAN setting, use the following procedure.
1.
Start the Configuration/Setup Utility program. See "Setup Utility program" on
page 5.
2.
Select Advanced Power Management.
3.
Select Automatic Power On from the program menu.
4.
Select Wake on LAN from the Automatic Power On menu.
5.
To enable Wake on LAN, select Enabled. To disable Wake on LAN, select
Disabled.
6.
Press Esc until you return to the Configuration/Setup Utility program menu.
7.
Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
8.
To exit from the Configuration/Setup Utility program, press Esc and follow the
instructions on the screen.
Additional service information
97

Advertisement

Chapters

Table of Contents
loading

Table of Contents