IBM IntelliStation 6866 Hardware Maintenance Manual page 47

2) From the rear of the rack enclosure, insert two long screws through the
slide bracket and mounting rail; then, tighten the screws.
3) If it was necessary to adjust the length of the slide rails, tighten the nuts
on the slide rail, using pliers, a socket wrench, or an adjustable wrench.
4. Attach the slide rail to the right side of the rack enclosure.
a. Extend the outer slide rail until the slide bracket is flush against the outside of
the right front mounting rail. Align the slide bracket with the cage nuts on
the mounting rail.
b. From the front of the rack enclosure, insert two long screws through the slide
bracket and mounting rail. Press the slide rail so that it is flush with the outer
edge of the mounting rail and tighten the screws.
c. Attach the slide bracket to the right rear of the rack enclosure.
1) Align the holes on the bracket with the cage nuts on the rear mounting
rail.
39
FRU replacements