Battery Removal And Installation - IBM IntelliStation 6866 Hardware Maintenance Manual

3.
4.
5.
6.

Battery removal and installation

1.
2.
3.
4.
5.
6.
7.
8.
26
IBM IntelliStation Type 6866: Hardware Maintenance Manual
Disconnect the memory power cable and the hard disk drive fan cable on the
memory card.
Push the tab on the back of the memory card inward and pull the memory card
out of the chassis. see "Removing a RIMM or C-RIMM" on page 20.
Remove any long adapters installed in the PCI slots.
Press the latch tabs on the card guide/fan assembly to release it, move the
assembly towards the back and out of the chassis.
Turn off the computer and all attached devices.
Unplug the power cord.
Remove the cover.
Remove the memory card (see "Removing a RIMM or C-RIMM" on page 20).
Remove any long adapters installed in the PCI slots (see "Installing long
adapters" on page 27).
Remove the card guide/fan assembly (see "Card guide/fan assembly removal"
on page 25).
Locate the battery. Refer to the system board label inside your computer or see
"System board layout" on page 17.
Remove the old battery.