IBM IntelliStation 6866 Hardware Maintenance Manual page 108

DANGER
To avoid a shock hazard, do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical storm.
To avoid shock hazard:
•
•
When possible, use one hand to connect or disconnect signal cables to prevent a possible shock
from touching two surfaces with different electrical potentials.
Electrical current from power, telephone, and communications cables is hazardous. To avoid
shock hazard, connect and disconnect cables as described following when installing, moving,
or opening covers of this product or attached devices.
CAUTION:
When replacing the battery, use only IBM Part Number 33F8354 or an equivalent type
battery recommended by the manufacturer. If your system has a module containing a
lithium battery, replace it only with the same module type made by the same
manufacturer.
The battery contains lithium and can explode if not properly used, handled, or
disposed of.
Do not:
•
•
•
Dispose of the battery as required by local ordinances or regulations.
100
IBM IntelliStation Type 6866: Hardware Maintenance Manual
The power cord must be connected to a properly wired and earthed receptacle.
Any equipment to which this product will be attached must also be connected to properly
wired receptacles.
To Connect
1. Turn Everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to receptacles
4. Attach power cord(s) to outlet.
5. Turn device ON.
Note: In the UK, by law, the telephone cable
must be connected after the power
cord.
Throw or immerse into water
Heat to more than 100°C (212°F)
Repair or disassemble
To Disconnect
1. Turn Everything OFF.
2. First, remove power cord(s) from outlet.
3. Remove signal cables from receptacles.
4. Remove all cables from devices.
Note: In the UK, the power cord must be
disconnected after the telephone cable.