Table of Contents
Advertisement
Diagnostic Error Code
011-198-XXX Serial port test aborted
011-199-XXX Serial port test failed, cause unknown
011-2XX-XXX Serial port signal failure
014-000-XXX Parallel port Interface Test Passed
014-001-XXX Parallel port Presence
014-002-XXX
014-003-XXX Parallel port Timeout/Parity error
014-013-XXX
014-014-XXX Parallel port Control Signal/Loopback test
failure
014-015-XXX Parallel port External Loopback failure
014-027-XXX Parallel port Configuration/Setup error
014-03X-XXX
014-04X-XXX Parallel port failure
014-195-XXX Parallel port Test aborted by user
014-196-XXX Parallel port test halt, error threshold
exceeded
014-197-XXX Parallel port test warning
014-198-XXX Parallel port test aborted
014-199-XXX Parallel port test failed, cause unknown
54
IBM IntelliStation Type 6866: Hardware Maintenance Manual
FRU/Action
1.
If a component is called out, make sure it is
connected and/or enabled
2.
Flash the system and re-test
3.
Go to the "Undetermined problems" section
1.
Go to the "Undetermined problems" section
2.
Flash the system and re-test
3.
Replace component under function test
1.
External serial device
2.
System board
1.
No action
1.
Remove external parallel device, if present
2.
Run setup, enable port
3.
System board
1.
System board
1.
System board
1.
Wrap plug
2.
System board
1.
Run Setup, enable port
2.
Flash the system
3.
System board
1.
System board
1.
Information
2.
Re-start the test, if necessary
1.
Press F3 to review the log file
2.
Re-start the test to reset the log file
1.
Make sure the component that is called out is
connected and/or enabled
2.
Re-run test
3.
Component that is called out in warning statement
4.
Component under test
1.
If a component is called out, make sure it is
connected and/or enabled
2.
Flash the system and re-test
3.
Go to the "Undetermined problems" section
1.
Go to the "Undetermined problems" section
2.
Flash the system and re-test
3.
Replace component under function test
Advertisement
Chapters
Table of Contents
