Specifications; Troubleshooting - Konica Minolta magicolor 8650 User Manual

16
16.6

Specifications

Specifications
Product name
Dimensions
Weight
Power requirements
Environment conditions
(when operating)
Environment conditions
(when not operating)
Radio waves classification
Compatible card
Computer
Supported operating systems
16.7

Troubleshooting

If a problem occurs while running the system, refer to the following.
Condition
The message appears on a compu-
ter where registration failed.
The message "Failed to Auth." ap-
pears on the machine.
Scanning does not begin.
The Add New Hardware Wizard
starts when this device is connected
to the computer.
If the problem is not corrected after the described operation is performed, contact your technical
representative or the manufacturer.
16-16
Authentication unit (IC card type) AU-201
Approx. 92mm (W) e 64mm (D) e 16mm (H)
Approx. 120 g
Through USB port
Temperature 32 to 104 °F (0 to 40 °C)
Humidity 20 to 85% (Must be no condensation)
Temperature -4 to 122 °F (-20 to 50 °C)
Humidity 20 to 85% (Must be no condensation)
Induced reading/writing communication equipment
Contactless IC card compliant with ISO 14443 Type A and
Felica
Processor PC/AT compatible, 1 GHz or more
Memory 128 MB or more
Hard disk drive Available hard disk space: 100 MB or more
Monitor 800 e 600 pixels, 16-bit color or more
Network TCP/IP protocol
Application Microsoft Internet Explorer 6.0 (Service Pack 1) or later
Microsoft .NET Framework (Service Pack 1) or later
Interface USB 1.1 or later
Windows 2000 Professional (Service Pack 4)
Windows XP Professional Edition (Service Pack 2)
Possible cause
With this device, the scanning time
is limited to 10 seconds. This mes-
sage appears if scanning was not
possible within the limited period of
time.
If "Card Authentication + Password"
was selected:
Is the password typed in correctly?
Was the machine restarted after this
device was connected to it?
Is this device connected to the same
USB port used when the driver was
installed?
Authentication unit (IC card type AU-201)
Remedy
Refer to "Positioning the IC card" on
page 16-5 and check how to position
the IC card in order to complete scan-
ning within the limited period of time.
Check the password, and type it in
correctly.
Turn the machine off with the power
switch and temporarily disconnect the
USB cable from this device or the ma-
chine before connecting it again and
waiting 10 seconds before turning on
the multifunctional product with the
power switch.
If this device is connected to a USB
port different from the one used when
the driver was installed, the Add New
Hardware Wizard may start. Use the
same USB port used when the driver
was installed.
magicolor 8650