Table of Contents
Advertisement
6 Installation
6.1 Overview: Installation
6.2 Opening the indoor unit
6.2.1 To remove the front panel
FTXP50~71M2V1B + FTXF20~71A2V1B + ATXF50~71A2V1B
Daikin room air conditioner
4P513661-8H – 2019.12
This chapter describes what you have to do and know on-site to install the system.
Typical workflow
Installation typically consists of the following stages:
1
Mounting the outdoor unit.
2
Installing the indoor unit.
3
Connecting the refrigerant piping.
4
Checking the refrigerant piping.
5
Charging refrigerant.
6
Connecting the electrical wiring.
7
Finishing the outdoor installation.
8
Finishing the indoor installation.
INFORMATION
For installation of the outdoor unit (mounting the outdoor unit, connecting the
refrigerant piping to the outdoor unit, charging refrigerant, connecting the electrical
wiring to the outdoor unit ...), see the installation manual of the outdoor unit.
1 Hold the front panel by the panel tabs on both sides and open it.
a
Panel tabs
2 Remove the front panel by sliding it to the left or the right and pulling it
toward you.
Result: The front panel shaft on 1 side will be disconnected.
3 Disconnect the front panel shaft on the other side in the same manner.
a
a
Front panel shaft
6
Installation
|
a
Installer reference guide
23
Advertisement
Table of Contents
