Image Access WideTEK 36 DS Manuals page 110

Error codes, part 2
Error Error message shown in
# the display
30
31
32
33
55 Error 55: Wrong S2N Board
(CCD Ports)
56 Error 56: S2N Board: wrong
revision
60 Error 60: General camera
error
61 Error 61: Loading camera 1
failed
62 Error 62: Loading camera 2
failed
63 Error 63: Loading camera 3
failed
65 Error 65: Camera 1 data bus
error
66 Error 66: Camera 2 data bus
error
67 Error 67: Camera 3 data bus
error
69 Error 69: ADC error camera 1 Camera 1 adc error.
Page 110
Error message sent to
application
File format not supported.
Preview not possible.
Invalid color conversion
No image available
Wrong S2N board detected
(not enough CCD ports)
Wrong S2N Board detected
(Revision not OK)
General camera error.
Load camera 1 failed.
Load camera 2 failed.
Load camera 3 failed.
Camera 1 data bus error.
Camera 2 data bus error.
Camera 3 data bus error.
Problem description
The specified file format is not supported
or it is invalid in combination with the
color mode.
The application specified an invalid
preview scale. Not all scale factors are
allowed with all image sizes.
The application changed the color depth
between scanning and image transfer
and a conversion between these modes
is not possible. Example: scan in binary,
then changed color mode to truecolor.
The application attempted to get an
image from the scanner and there was
no scan since the device was turned on.
The S2N board found is not the right one
for this device. Error can occur after a
repair/exchange. Exchange with correct
board.
The S2N board found is not the right one
for this device. Error can occur after a
repair/exchange. Exchange with correct
board.
General error on the CCD camera
board. Check power, cables and S2N-
PCI board.
Initializing of camera 1 failed. Check
power, cables and S2N-PCI board.
Initializing of camera 2 failed. Check
power, cables and S2N-PCI board.
Initializing of camera 3 failed. Check
power, cables and S2N-PCI board.
Test data transfer to camera failed.
Check cables / connectors to camera 1
and S2N-PCI board.
Test data transfer to camera failed.
Check cables / connectors to camera 2
and S2N-PCI board.
Test data transfer to camera failed.
Check cables / connectors to camera 3
and S2N-PCI board.
Test data transfer through analog digital
converter failed. Check cables /
connectors to camera 1.
Manual