Sort Mode; Staple Mode - Develop QC 2235 Plus Service Manual

QC 2235plus Theory of Operation Ver.1.0 Mar. 2004
4.2.2

Sort mode

• In the Sort Mode, Paper is taken back onto the Finishing Tray and shifted to the front or rear side with
the Aligning Plate. Then, a stack of paper per set is fed out onto the Elevator Tray.
• However, even if printing has not been completed for all sets of prints, when 10 sheets for the large
size whose length is longer than 300mm or 30 sheets for the small size whose length is shorter than
299mm are stacked, a set of sheets is fed out onto the Elevator Tray.
Paper Stacking for 4 sets in Sort Mode
3rd set
1st set
Paper Transport
Finishing Tray
4.2.3

Staple Mode

• In the Staple Mode, when one complete set of prints is fed out onto the Finishing Tray,
stapling is performed. A stack of stapled paper is then fed out onto the Elevator Tray.
Paper Transport
Finishing Tray
4th set
2nd set
Shifted with the Aligning Plate for each job
Stapling for one set of prints
2-7
Mechanical operations
Elevator Tray
Elevator Tray