Registration Clutch
Removal
1.
Remove the Rear Cover.
2.
Remove the Flywheel Assembly.
3.
Disconnect P/J 200 from the Registration Clutch.
4.
Remove the E clip securing the Registration Clutch to the Registration Shaft.
5.
Push out on the shaft latch as you slide the Clutch off of the shaft.
Replacement
1.
Slide the Registration Clutch onto the shaft. The shaft latch snaps the Clutch into
place on the shaft.
2.
Use an E clip to secure the Registration Clutch to the Registration Shaft.
3.
Reconnect P/J 200 from the Registration Clutch.
4.
Reinstall the Flywheel Assembly.
5.
Reinstall the Rear Cover.
4025-XXX
4-51
Repair Information