Tray 1 Retard Assembly - Lexmark W820 Service Manual

Tray 1 Retard Assembly

Removal
1.
Remove Tray 1 Take Away Roll Assembly.
2.
Remove the Left Middle Cover.
3.
Remove the screw securing the Feed In Chute to the Assembly and slide the Chute
to the front of the Assembly to remove it.
4.
Remove the plastic Feed Chute from the Take Away Roll.
5.
Unhook the spring from the Retard Support.
6.
Remove Tray 1 Support Assembly Spring.
7.
Remove the screw securing the Gear Stopper to the Assembly, and move the
Stopper out of the way.
8.
Remove the E ring securing Gear 22/20 to the shaft and remove the Gear.
9.
Remove the plastic bearing securing the Take Away Roll Shaft to the front of the
Retard Frame, and remove the Retard Assembly and Take Away Roll.
10.
Remove the E rings and Gears attached to the rear of the Take Away Roll Shaft.
11.
Remove the Center Bearing on the Take Away Roll Shaft, and slide the Roll out of
the Retard Support.
Replacement
1.
Reinstall the Take Away Roll Shaft onto the Retard Support.
2.
Reinstall the Center Bearing onto the Take Away Roll Shaft, and secure the Shaft to
the Support.
3.
Reinstall the Gears and E rings to the rear of the Take Away Roll Shaft.
4.
Reinstall the Retard Assembly and Take Away Roll back into the Retard Frame.
5.
Reinstall the plastic bearing into the hole at the front of the Retard Frame.
6.
Reinstall Gear 22/20 to the rear of the shaft, and use an E ring to secure the Gear.
7.
Align the screw hole in the Gear Stopper with the screw hole in the frame, and use
one screw to secure the Stopper.
8.
Reinstall the Tray 1 Support Assembly Spring.
9.
Reattach the spring to the Retard Support.
10.
Reinstall the plastic Feed Chute to the Take Away Roll.
11.
Reinstall the Feed In Chute, and use one screw to secure it to the Assembly.
12.
Reinstall the Left Middle Cover.
13.
Reinstall Tray 1 Take Away Roll Assembly.
4025-XXX
4-25
Repair Information