Actuator Assembly
Removal
1.
Remove the paper tray from the printer.
2.
Turn the tray upside down.
3.
Remove the two E rings securing the two cable pulleys to the Rear Bracket and
carefully remove the pulleys from the tray.
4.
Remove the two screws securing the Rear Bracket to the paper tray and move the
Bracket far enough so you can remove the Actuator Assembly.
Replacement
1.
Reinstall the Actuator Assembly onto the rear of the paper tray, making sure the two
pulley shafts fit through the slot in the Rear Bracket.
2.
Reinstall the Rear Bracket and use two screws to secure the Bracket to the tray.
3.
Reinstall the two cable pulleys on the pulley shafts, making sure the cables are
attached to the pulley.
4.
Use two E rings to secure the pulleys to the shafts.
5.
Slide the paper tray Side Guide back and forth as you observe the Actuator
Assembly to make sure it slides smoothly and without binding.
6.
Reinstall the paper tray into the printer.
4025-XXX
4-33
Repair Information