Lexmark W820 Service Manual page 283

Removal
1.
Remove the Exit Drive Assembly.
2.
Remove the four screws securing the Drive Support to the Inverter Bracket and lift
the Support from the Bracket.
3.
Disconnect P/J218 and P/J219, and free the wire harness from the harness clips.
4.
Slide the CCW Gear from the CCW Clutch.
5.
Slide the CW Gear fro the CW Clutch.
6.
Lift the CCW Clutch from the bearing and remove the Clutch.
Replacement
1.
Reinstall the two bearings into the cutouts in the Inverter Bracket.
2.
Position the CW Clutch so the gear faces away from the Bracket and insert the shaft
at the rear of the Clutch into the bearing. Make sure the notch in the Clutch hooks
onto the tab on the Bracket.
3.
Position the CCW Clutch so the gear faces away from the Bracket and insert the
shaft at the rear of the Clutch into the bearing. Make sure the notch in the Clutch
hooks onto the tab on the Bracket.
4.
Reinstall the CW Gear onto the CW Clutch shaft.
5.
Reinstall the CCW Gear onto the CCW Clutch shaft.
6.
Route the wire harness under the harness clips and reconnect P/J218 and P/J219.
7.
Carefully reinstall the Drive Support onto the Inverter Bracket, making sure the
Clutch shafts fit into the bearings in the Support.
8.
Use the four screws to secure the Drive Support to the Inverter Bracket.
9.
Reinstall the Exit Drive Assembly.
4025-XXX
4-75
Repair Information