Lexmark W820 Service Manual page 256

Removal
1.
2.
3.
4.
Replacement
1.
2.
3.
4.
5.
6.
7.
4-48
Service Manual
Remove the Left Lower Cover Assembly.
Remove the three screws securing the Pinch Roll Bracket to the Assembly, and
remove the Bracket.
Unhook the two Pinch Roll Springs and lift the Pinch Roll out of the Bracket.
Remove the two Center Bearings and the two End Bearings from the Roll.
Reinstall an End Bearing to each end of the Pinch Roll.
Reinstall the Pinch Roll onto the Bracket. Make sure that the lip of each Bearing is
trapped behind the tabs in the Bracket.
Hook one end of each Pinch Roll Spring into a spring hole in one side of the Bracket.
Bring the Springs over the Pinch Roll Shaft and hook the other end of each Spring
into the spring hole on the opposite side of the Bracket.
Slide a Center Bearing under each Pinch Roll Spring, as shown.
Reinstall the Bracket onto the Left Lower Cover Assembly, and use three screws to
secure it to the Assembly.
Reinstall the Left Lower Cover Assembly.
4025-XXX