Removal
1.
Unplug the AC Power Cord from the rear of the printer.
2.
Remove the Fuser Full Cover.
3.
Disconnect J204 from the Fuser Fan.
4.
Remove the two screws securing the right side of the Top Cover Assembly to the
Right Cover (Figure 1).
5.
Carefully lift the Top Cover a few inches off of the printer frame.
6.
Disconnect the P/J417 from the Operator Panel, and lift the Top Cover Assembly off
of the printer frame.
Replacement
1.
Unplug the AC Power Cord from the rear of the printer.
CAUTION: Do not reinstall the Top Cover while the AC Power Cord is connected to the
printer. While reinstalling the Top Cover you may accidently switch on the Main Power
Switch.
2.
Reconnect P/J417 to the Operator Panel.
3.
Reinstall the Top Cover Assembly onto the printer frame.
4.
Make sure the screw holes at the right side of the Top Cover line up with the screw
holes in the printer frame, and the left end of the Cover is under the Exit Chute Pinch
Rolls.
5.
Use two screws to secure the Top Cover Assembly to the Right Cover.
6.
Reconnect J204 to the Fuser Fan.
7.
Reinstall the Fuser Full Cover.
4025-XXX
4-5
Repair Information