Lexmark W820 Service Manual page 211

Removal
1.
Remove the Mailbox or the Finisher if installed.
2.
Open the Duplex Unit if installed.
3.
Pull back and remove the Paper Assembly Damper.
4.
Open the Left Upper Cover Assembly and remove the screw securing the Fuser
Cover to the frame (Figure 1).
5.
Open the Front Cover and remove the screw securing the Fuser Cover to the frame
(Figure 1).
6.
Lift the Fuser Cover off of the Top Cover Assembly.
Replacement
1.
Open the Duplex Unit if installed.
2.
Open the Left Upper Cover.
3.
Slide the tabs that are located at both ends of the Cover into the corresponding
openings in the Top Cover Assembly (Figure 2).
4.
Lower the Fuser Full Cover onto the Fuser Assembly.
5.
Press the Fuser Full Cover into place. Make sure the tabs remain in place, the Fuser
Full Cover meshes smoothly with the Top Cover, and the two screw holes in the
Fuser Full Cover line up with the holes in the printer frame.
6.
Use two screws to secure the Fuser Full Cover.
7.
Reinstall the Paper Assembly Damper.
4025-XXX
4-3
Repair Information