Registration Chute - Lexmark W820 Service Manual

Registration Chute

Removal
1.
2.
3.
4.
5.
6.
7.
8.
Replacement
1.
2.
3.
4.
5.
6.
7.
8.
9.
4-54
Service Manual
Remove the Left Upper Cover Assembly.
Remove the Registration Clutch.
Remove the screw securing the Inner Cover to the printer frame, and remove the
Inner Cover.
Remove the EP Cartridge.
Remove the screw securing the Magnet Plate to the printer frame, and remove the
Plate.
Remove the two screws (under the Magnet Plate) securing the front of the
Registration Chute to the printer frame.
Remove the two screws (under the Registration Clutch) securing the rear of the
Registration Chute to the printer frame, and remove the Chute.
Disconnect P/J200 from the Registration Sensor.
Reconnect P/J200 to the Registration Sensor.
Reinstall the Registration Chute Assembly into the printer frame. Make sure the
mylar strip is on the outside of the Chute.
Align the four screw holes (two at each end) in the Registration Chute with the four
screw holes in the printer frame.
Use two screws to secure the Chute to the front of the frame, and use two screws to
secure the Chute to the rear of the frame.
Reinstall the Magnet Plate to the printer frame, and use one screw to secure the
Plate.
Reinstall the Inner Cover to the frame, and use one screw to secure the Cover.
Reinstall the Left Upper Cover Assembly.
Reinstall the Registration Clutch.
Reinstall the EP Cartridge.
4025-XXX