Mp Feeder Support Assembly - Lexmark W820 Service Manual

MP Feeder Support Assembly

Removal
1.
Remove the MP Feeder Assembly.
2.
Remove the one screw securing the Front Support Cover to the Support Assembly,
and remove the Cover.
3.
Remove the one screw securing the Rear Support Cover to the Support Assembly,
and remove the Cover.
4.
Remove the Rear Cover Assembly.
5.
Disconnect J603.
6.
Remove the four screws securing the MP Feeder Support Assembly to the printer
frame, and remove the Assembly.
Replacement
1.
Position the MP Feeder Support Assembly a few inches from the printer frame.
2.
Insert the wire harness into the cutout in the printer frame.
3.
Slide the two positioning pins that are located at both ends of the Support Assembly
into the holes in the frame.
4.
Use four screws to secure the Assembly to the frame.
5.
Reconnect J603.
6.
Reinstall the Rear Cover Assembly.
7.
Reinstall the Rear Support Cover and use one screw to secure it to the Support
Assembly.
8.
Reinstall the Front Support Cover and use one screw to secure it to the Support
Assembly.
9.
Reinstall the MP Feeder Assembly.
4025-XXX
4-43
Repair Information