Table of Contents
Advertisement
2
Cautions on Installation of panel-mounted USB port extension
(1) Run power lines, servo amplifier drive wires, and panel-mounted USB port extension so that they
do not cross each other.
(2) Keep the panel-mounted USB port extension away from any equipment which can become noise
source.
(3) Do not twist, bend at a sharp or right angle or pull the panel-mounted USB port extension. Such
handling may cause wire breakage.
(4) Install the panel-mounted USB port extension under consideration of the dimensions inside the
panel shown below.
• Dimension between GOT rear face and structure
• Cable protrusion dimension
(5) Insert securely the small USB plug provided at the tip of the panel-mounted USB port extension
into the USB port in the GOT.
Fix the panel-mounted USB port extension itself to a structure inside the board using Insulock, etc.
because the small USB plug may become loose or come off due to vibration, impact or tensile
force.
(6) Confirm at the start of work or during operation that this product is offering its function and
performance normally, and then use this product.
8 - 34
8.10 Panel-Mounted USB Port Extension
8.10.3 Installing procedure
80(3.15") or more
Unit: mm(inch)
80(3.15") or more
Unit: mm(inch)
Advertisement
Table of Contents
