Table of Contents
Advertisement
3
The oil cover was hung and the edge of the oil cover is
sequentially obtained and obtain the oil cover to cover rubber
packing parts in the back of GOT of the front panel.
(It is the order of the arrow from A side to D side.)
Please confirm all surroundings.
Check whether the rubber packing is fitted correctly into the
groove on the under side of the GOT front panel, and then
whether the protective cover for oil securely covers the
rubber packing part to prevent invasion of liquids into the
board.
4
Mount the GOT onto the control panel.
When the control panel is dirty, clean the control panel.
The panel cutting dimensions and mounting screw
tightening torque with the protective cover for oil are
the same as those without the cover.
Mount the GOT onto the control panel by referring to
Chapter 6.
8 - 28
8.7 Protective cover for oil
8.7.2 Installing procedure
(1) Cautions on installation
The mounting screw should be tightened by specified torque. Undertightening of
mounting screws can cause a drop, and deteriorate the waterproof effect and
oilproof effect. Overtightening of mounting screws can cause a drop due to
damage of the GOT or mounting fixtures, and deteriorate the waterproof effect
and oilproof effect.
(2) Precautions for protective cover for oil
• The protective cover for oil is consumable product.
Check the cover for scratch, damage or dirt at regular intervals, and replace
with new one if necessary.
• Do not push the protective cover for oil with pointed tools, including
mechanical pencils and screwdrivers.
Doing so causes scraches and damages of the cover.
• Do not clean the protective cover for oil with bleaches, thinners, organic
solvents, corrosive chemicals, and others. Doing so causes changes in
shape and color of the cover.
• When the protective cover for oil is attached to the GOT, do not stretch and
bend the cover too much.
Doing so may cause a separation between the sheet and rubber.
• Do not place or use the protective cover for oil in direct sunshine.
• When the protective cover for oil gets dusts, wipe the dusts off with a damp
cloth.
• Do not do a frequent detaching the protective cover for oil. It causes
deterioration in the oil performance, the medicine performance.
• It is not the one to guarantee all customer's environments. Moreover, it is
not likely to be able to use it in the environment to which oil splashes for a
long time and the environment with which Oilmist is filled.
The corner on the left is hung and the oil
cover is hung from A side to D side on the
starting point sequentially.
A
D
C
Make sure that corners of protective
cover for oil match those of GOT front.
Panel cut
dimensions
Protectivecover
for oil
Mounting metal fixture
Control panel
B
Advertisement
Table of Contents
