Mitsubishi GT10 User Manual page 81

2 Inserting into the panel face
Insert the GOT from the front side of the panel.
(Right drawing is the example of lateral format.)
3 Fixing the GOT
1) Insert the hooks on the mounting fittings (supplied) into the mounting holes on the GOT unit.
2) Slide the mounting fittings to the back end.
3) Slide them to the left to lock them in place, and then fix them with the mounting screws (supplied).
The GOT will be fixed in 4 upper/lower parts.
Mounting Mounting
screw fitting
2)
1)
For GT1020, GT1030, GT104
Cautions on installation
Tighten the mounting screw with the specified torque. Undertightening of mounting
screws can cause a drop, and deteriorate the waterproof effect and oilproof effect.
Failure to do so may damage the unit, or distort the panel and make a surface
waviness on the display area, leading to deterioration of the visibility or incorrect
input from the touch panel. In addition, the waterproof effect and oilproof effect may
not be available due to the "distortion" of GOT or panel.
Tightening torque
4 A protection film is attached on the display section of GOT prior to shipment.
Remove the film when the installation is completed.
3)
GOT
GT1020, GT1030, GT104
0.20 to 0.25 N•m
Magnified illustration
Mounting fitting
Mounting screw
For GT105
GT105
0.3 to 0.5 N•m
6.5 Installation Procedure
6.5.1 Installation procedure
1
2
Mounting hole
3
4
5
6
7
8
6 - 11