Yamaha XVS650 Service Manual page 345

IQI To the throttle position sensor (TPS).
[B] To the carburetor.
OJ
To the fuel tank.
Q] Pass the neutral switch lead, pickup coil lead
and A.C. magneto lead under the ignition coil
lead, thermo switch lead and throttle position
sensor (TPS) lead.
lRl
From the engine.
UJ
20 mm (0.79 in)
lMl
Pass the thermo switch lead inside of the
silencer breather hose.
CABLE ROUTING
I
SPEC
I
~
I
[ill Fasten the wire harness and throttle position
sensor (TPS) lead with a plastic locking tie.
!Q] Inside the motorcycle.
[f] Route the wire harness and throttle position
sensor (TPS) lead so they run along the bottom
of the frame tube.
[Q] Place the end of the plastic locking tie as
shown.
[ill Fasten the wire harness with a plastic locking tie.
[§] Pass the wire harness between the air filter
case groove and frame.
A-A
==
7
B-B
-
c-c
- = =
-12 -