Yamaha XVS650 Service Manual page 183

MIDDLE GEAR
ENG
2
6mm
26mm
4.1nstall:
• Middle driven shaft assembly
**********************************
Install steps:
• Clean the outside of the middle driven
shaft and the inside of the bearing.
• Fit the middle driven shaft assembly onto
the bearing housing.
• Place the middle driven shaft assembly
onto a hydrau lic press.
• Never directly press the shaft end with a
hydraulic press, this will result in damage
to the shaft thread.
• Install the hand-made tool
CD
to protect
the bearing and bearing housing from
damage.
• Install the wood piece e.g) on the shaft end
to protect the thread from damage.
• Press the wood piece and secure the mid-
dle driven shaft assembly.
**********************************
5.Tighten:
• Nut (middle driven pinion gear)
CD
[~]90 Nm (9.0
m . kg,
65.1
ft . Ib)
I
NOTE:
Use the universai joint holder
®
to hold the
yoke@.
'. Universal joint holder:
YM-04062, 90890-04062
4 -76
6.1nstall:
• Yoke (cross joint)
CD
(into the hole on yoke)