Table of Contents
Advertisement
Digital Network Video Surveillance System
Region: Click select button, the interface is shown as in
zone. There are 396(PAL)/330(NTSC) small zones. The green zone is current cursor position. Grey zone is the
motion detection zone. Black zone is the disarmed zone. You can click Fn button to switch between the arm
mode and disarm mode. In arm mode, you can click the direction buttons to move the green rectangle to set
the motion detection zone. After you completed the setup, please click ENTER button to exit current setup. Do
remember click save button to save current setup. If you click ESC button to exit the region setup interface
system will not save your zone setup.
Sensitivity: System supports 6 levels. The sixth level has the highest sensitivity.
Show message: System can pop up a message to alarm you in the local host screen if you enabled this
function.
Alarm upload: System can upload the alarm signal to the network (including alarm centre) if you
enabled current function.
Send email: System can send out email to alert you when alarm occurs.
MMS: Highlight the icon to enable this function. System can send out a message to the user once an alarm
occurs.
Period: Click set button, you can see an interface is shown as in
business day and non-business day. In
Figure 4-20. Here you can set your own setup for business day and non-business day.
X308H308H308H
Anti-dither: Here you can set anti-dither time. If you input 10 seconds here, then the motion detect signal
will last for 10 seconds and then disappear. Please note, this function is for motion detect only. It does not
support camera masking and video loss.
Alarm output: when alarm occurred, system enables peripheral alarm devices.
Tour: Here you can enable tour function when alarm occurs. It is a one-window tour. Please go to chapter
5.3.9 Display for tour interval setup.
Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm occurs.
Please highlight icon
system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in each
channel may not be the same.
In
Figure 4-18
, you can left click mouse and then drag it to set a region for motion detection. Click Fn to
X309H309H309H
X
switch between arm/withdraw motion detection. After setting, click enter button to exit.
Figure 4-19
X307H307H307H
to select the corresponding function. After all the setups please click save button,
Figure 4-18
Here you can set motion detection
X304H304H304H
.
Figure 4-19
X306H306H306H
, click set button, you can see an interface is shown as in
X
Unisight Digital Technologies, Inc.
. Here you can set for
X
45
Advertisement
Table of Contents
