Table of Contents
Advertisement
Digital Network Video Surveillance System
Please refer to chapter 5.3.5.3 for detailed multiple cast setup information.
PPPoE
Please input the PPPoE user name and password you get from the IPS (internet service provider) and
enable PPPoE function. Please save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN from the IP
address column.
Note:
After PPPoE successful dial, you need to go to the device local end to get device current IP address and
then use the client-end to access this IP address.
Alarm
Alarm setup interface is shown as in
Please make sure you have connected the corresponding alarm output device such as the light, buzzer
and etc.
Figure 7-93
Figure 7-39.
X467H467H467H437H437H437H444H407H
Unisight Digital Technologies, Inc.
118
Advertisement
Table of Contents
