Unisight M4Core D-Seres Manual page 122

Digital Network Video Surveillance System
Parameter Function
Event There are three types: Motion detection/video loss/Camera Masking.
Type
Channel Select channel name from the dropdown list.
Enable You need to draw a circle to enable motion detection function.
Sensitivity There are six levels. The sixth level has the highest sensitivity.
Region There are six levels. The sixth level has the highest sensitivity.
Region: If you select motion detection type, you can click this button to
set motion detection zone. The interface is shown as in
X469H469H469H439H439H439H446H409HFigure 7-96. There are
PAL 22X18/NTSC 22X15 zones. Right click mouse you can go to full-
screen display mode. Do remember clicking OK button to save your
motion detection zone setup.
Period Motion detection function becomes activated in the specified periods.
There are six periods in one day. Please draw a circle to enable
corresponding period.
Select date. If you do not select, current setup applies to today only.
You can select all week column to apply to the whole week.
Click OK button, system goes back to motion detection interface;
please click save button to exit.
Anti-dither System only memorizes one event during the anti-dither period. The
value ranges from 0s to 15s.
Normal There is 2-channel alarm output.
out Corresponding to motion detection alarm output port(multiple choices)
Enable alarm activation function. You need to select alarm output port
so that system can activate corresponding alarm device when alarm
occurs.
Alarm System can delay the alarm output for specified time after alarm
latch ended. The value ranges from 1s to 300s.
Alarm System can upload the alarm signal to the centre (Including alarm
upload centre.
Record System auto activates motion detection channel (multiple choices) to
channel record once alarm occurs (working with motion detection function).
Please note you need to go to Chapter 4.4 Schedule to set motion
detection record period and go to chapter 4.2 Manual Record to set
current period as auto record.
Record System can delay the record for specified time after alarm ended. The
latch value ranges from 10s to 300s.
SMS Once you checked the box here, the device can send out the
message to the specified cell phone when alarm occurs.
Email If you enabled this function, System can send out email to alert you
when alarm occurs and ends.
Tour Display the selected video in local monitor window.
Tour interval and tour mode are set in DVR local menu (chapter 5.3.9
Display )
Buzzer Once you checked the box here, the buzzer beeps when an alarm
occurs.
Unisight Digital Technologies, Inc.
122