Alarm I/O; Record - Unisight M4Core D-Seres Manual

Digital Network Video Surveillance System
Parameter
Recover
Please note system needs to reboot to activate current setup.

Alarm I/O

Here you can search alarm output status. See
Important
The alarm output port should not be connected to high power load directly (It shall be less than 1A) to avoid
high current which may result in relay damage. Please use the co contactor to realize the connection
between the alarm output port and the load.
Please refer to the following sheet for detailed information.
Parameter
Alarm output
Activate
Refresh

Record

Record control interface is shown as in
Function
Recover dada after an error occurs.
.
X473H473H473H443H443H443H450H413HFigure 7-100X
Figure 7-100
Function
There are two output channels (Multiple choices).
Enable/disable alarm output device. After the Web activated the
alarm, you need to cancel the channel and then click the
activation button to cancel the alarm, or you need to cancel the
alarm in the pop-up dialogue box in local-end.
Search alarm output status.
.
X474H474H474H444H444H444H451H414HFigure 7-101X
Unisight Digital Technologies, Inc.
126