Sony PCS-TL50 Operating Instructions Manual page 200

To put a call on hold during a point-to-point videoconference
1
Press the CONNECT/DISCONNECT (
Commander during communication.
The following submenu appears.
1
2
Select "Hold" using the V, v, B or b button and the ENTER button on the
Remote Commander.
"On Hold (SIP)" appears on the displays of the local and remote sites.
Notes
• Dialing and answering a call are not available during a point-to-point
videoconference.
• If a call in a point-to-point videoconference is held during transmission or
reception of the data via the Data Solution Box or reception of the White Board
image, the transmission or reception is cancelled and will not be restored after the
hold mode is cancelled.
To cancel the hold mode of a point-to-point videoconference
You can cancel the hold mode only when you have operated the system to
enter the hold mode.
Press the CONNECT/DISCONNECT (
Commander while in the hold mode, select "Resume Call" from the submenu
and press the ENTER button. The hold mode is cancelled and you can
continue the conference.
200
Starting a Videoconference Using SIP
Disconnect
Hold
Transfer
2 3
Bob John OSAKA
/ ) button on the Remote
Phone Book
Detailed Dial
Cancel
4 5 6
NEW YORK
/ ) button on the Remote