Using External Microphone And Headphones - Sony PCS-TL50 Operating Instructions Manual

Using External Microphone and
Headphones
The microphone built in this system is assumed to be used to conduct a
conference among about three participants. You can connect the optional PCS-
A1 or PCSA-A3 microphone to the system, allowing more persons to
participate in the conference.
You can also connect headphones or headset to this system.
Right side
Notes
• To use the microphone connected to this system, set "Mic Select" to "Internal" in the
Audio Setup menu.
• The built-in microphone is disabled when an external microphone is connected.
• The built-in speakers are disconnected when headphones are connected.
Notes on installation of the microphones
• Install an external microphone more than 1 m (3.3 feet) away from this
system.
• Keep the microphone about 50 cm (19 3/4 inches) away from the
participants.
• Place the microphone in a quiet, echo-free location.
• Install microphones away from equipment that may cause noise.
• Avoid covering a microphone with paper, etc., or moving it. If you do either,
extreme noise and echo may be heard temporarily by the remote party. In this
case, wait until the echo disappears.
PCS-A1 (not supplied) or PCSA-A3
microphone (not supplied)
to m
to m
m
i
to i
to i

Using External Microphone and Headphones

Headset (not supplied)
Headphones (not supplied)
133