Sony PCS-TL50 Operating Instructions Manual page 249

Message
An IP address is not obtained via DHCP.
Please dial by entering the IP address.
Reference to DNS has failed.
Some trouble occurs during connection.
Connection has failed.
Check the information registered to the
gatekeeper.
Connection has been rejected as the data
exceeds the bandwidth of a gatekeeper.
Gatekeeper does not respond.
The ISDN Unit is not connected.
The ISDN line is invalid. Check the ISDN
connection.
ISDN lines are not connected correctly.
Check the ISDN configuration.
A telephone number of a remote party has
not been entered.
The entered telephone number of a remote
party is not correct.
Problems connecting to a router or an ISDN
connection.
Line is busy. Try to dial again later.
A line has not been completely connected.
The far-end videoconferencing system did
not respond to our calling.
The terminal with the specified IP address
does not exist, or the system is turned off.
Connection rejected.
Call not responded.
H.245 Error.
The remote terminal may not be compatible
with the BONDING function.
Meaning
Check the DHCP setting.
Be sure to enter the IP address of the remote party
when dialing.
The LAN connection has failed as you entered the
user name when using the domain name server.
Enter the IP address.
Try to connect again.
When you use the gatekeeper mode, the registered
information on gatekeeper appears in Page 2/2 of
the LAN Setup menu.
Connection has failed as the data exceeds the
bandwidth of a gatekeeper.
Check the gatekeeper setting.
The ISDN Unit is not connected.
Check the ISDN connection.
Check the ISDN connection.
Check the settings in the ISDN Setup menu.
Enter the telephone number of the remote party.
Enter the correct telephone number of the remote
party.
The ISDN connection has not been made. There
may be some problem in a router or in the ISDN
connection on the remote party.
Line is busy. Wait for a while and try dialing again.
The videoconferencing system does not respond to
the calling, and the connection has failed.
The connection to the remote party cannot be
made. You may specify a different IP address from
that of the terminal or the system of the remote
party is turned off.
The connection to the remote party has failed.
The remote party does not respond to your calling.
Error occurs while connecting to the multiple
points via LAN.
The BONDING function may not be used. The
remote terminal may not be equipped with this
function.
On Screen Messages
249