Sony PCS-TL50 Operating Instructions Manual page 33

When you select Auto SPID (only
for customers in the USA and
Canada)
You can automatically set up the Area
Code and Local Number on this page,
and SPID items in the SPID menu.
Notes
• When you select a blank text box and
press the ENTER button on the Remote
Commander, the content in the text box
immediately above will be copied to the
selected text box.
• When you use the PCSA-B384S ISDN
unit and connect 2 or 3 ISDN lines,
enter the telephone numbers in the B1
to C2 text boxes in addition to the A1
and A2 boxes.
When you use the PCSA-B768S and
connect 2 to 6 ISDN lines, enter the
telephone numbers in the B1 to F2 text
boxes in addition to the A1 and A2
boxes. To open the menu with D1 to
F2 text boxes, select "Next", then
press the ENTER button.
6
Use the V, v, B or b button to select
"Next", then press the ENTER button.
7
Enter the sub-addresses.
Only numerals are available for a sub-
address.
When you use one ISDN line, enter the
same number both in the A1 and A2 text
boxes (except for the USA and Canada).
Sub Address
A1
A2
B1
B2
C1
C2
Previous
Note
When you use the PCSA-B384S ISDN
unit and connect 2 or 3 ISDN lines, enter
the sub-addresses in the B1 to C2 text
boxes in addition to the A1 and A2 boxes.
When you use the PCSA-B768S and
connect 2 to 6 ISDN lines, enter the sub-
Next Cancel
Setting Up the System for the First Time — Initial Setup Wizard
addresses in the B1 to F2 text boxes in
addition to the A1 and A2 boxes. To open
the menu with these text boxes, select
"Next", then press the ENTER button.
8
Use the V, v, B or b button to select
"Next", then press the ENTER button.
For customers in other countries than
the USA and Canada
The LAN Setup Wizard appears.
For customers in the USA and
Canada
The ISDN Setup Wizard (SPID menu)
appears.
Set the SPID items, then select "Next"
and press the ENTER button.
The LAN Setup Wizard appears.
For details on the SPID settings, see
"SPID Setting for Customers in the USA
and Canada" on page 57.
Note
When you do not use the LAN, select
"Next" to display the message window for
confirmation, then proceed to step 11.
9
Set the following items on the LAN.
LAN Setup Wizard
DHCP Mode
Host Name
IP Address
Network Mask
Gateway Address
DNS Address
Previous
DHCP Mode: Sets the DHCP
(Dynamic Host Configuration
Protocol).
Auto: Automatically assigns your IP
address, network mask, gateway
address and DNS address.
Off: Deactivates DHCP. In this case
set your IP address, network mask,
gateway address and DNS address
manually.
Host Name: Enter your host name.
Off
. . .
. . .
. . .
. . .
Next Cancel
33