Positioning The Fork Protection; Removing The Fork Legs; Installing The Fork Legs - KTM 125 EXC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.6

Positioning the fork protection

11.7

Removing the fork legs

11.8

Installing the fork legs

–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line. Position the clamp and mount and tighten screws
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
B00800-11
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Remove cable binder
–
Remove screws
–
Hang the brake caliper and the brake line loosely to the side.
B00798-10
(EXC EU/AUS, XC‑W)
–
Loosen screws
–
Loosen screws
B00799-10
(EXC SIX DAYS)
–
Loosen screws
–
Loosen screws
B01214-10
x
Main work
(EXC EU/AUS, XC‑W)
–
Position the fork legs.
303637-10
x ( p. 82)
and take off the clamp.
1
.
2
and take off the brake caliper.
3
. Remove the fork leg on the left.
4
. Remove the fork leg on the right.
5
. Remove the fork leg on the left.
4
. Remove the fork leg on the right.
5
Info
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
Position bleeder screws toward the front.
1
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 46)
p. 90)
48
.
1
.
2