Changing The Front Brake Linings - KTM 125 EXC EU Owner's Manual

12 BRAKE SYSTEM
12.8

Changing the front brake linings

Warning
Danger of accident Brake system failure.
–
Maintenance work and repairs must be carried out professionally. (Your authorized KTM workshop will be glad to help.)
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents Reduced braking efficiency due to use of non-approved brake linings.
–
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construc-
tion and friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM
brake linings. If brake linings are used that differ from the originals, there is no guarantee that they comply with the origi-
nal license. The vehicle no longer corresponds to the condition at delivery, and the warranty is no longer valid.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
x
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Manually press the brake caliper toward the brake disc to push back the brake pis-
tons. Ensure that brake fluid does not flow out of the brake fluid reservoir, extract-
ing it by suction if it does.
Info
Make sure when pushing back the brake pistons that you do not press the
100395-10
brake caliper against the spokes.
–
Remove cotter pins
–
Clean the brake caliper and brake caliper support.
100396-10
.
1
with membrane .
2 3
, pull out pin , and remove the brake linings.
4 5
76