14
ELECTRICAL SYSTEM
14.5
Removing the headlight mask with the headlight
14.6
Refitting the headlight mask with the headlight
14.7
Changing the headlight bulb
Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
–
Switch off all power consumers.
–
Remove screw
–
Release rubber band
B00833-10
–
Disconnect the electrical plug-in connection
with the headlight.
303402-10
Main work
–
Connect the electric plug connector
303402-11
–
Position the headlight mask and fix it with the rubber band
Info
Ensure that the holding lugs engage in the fender.
–
Position the brake line and wiring harness. Put on the clamp and mount and
tighten screw
B00833-11
Finishing work
–
Check the headlight setting. (
Preparatory work
–
Remove the headlight mask with the headlight. (
and take off the clamp.
1
. Slide the headlight mask up and swing it forward.
2
.
1
.
3
p. 92)
and take off the headlight mask
3
.
2
p. 90)
90