11
SERVICE WORK ON THE CHASSIS
11.14
Installing the lower triple clamp
Finishing work
–
Mount the handlebar cushion.
–
Install the front fender. (
–
Install the front wheel.
–
Refit the headlight mask with the headlight. (
–
Check that the wiring harness, throttle cables and brake and clutch lines can move
freely and are routed correctly.
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
–
Check the headlight setting. (
(EXC SIX DAYS)
x
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Slide on protective ring
B01218-10
–
Position the upper triple clamp with the steering.
–
Mount screw
–
Position the clutch line and wiring harness.
B01219-10
–
Position the fork legs.
Info
The upper milled groove in the fork leg must be flush with the top edge of
the upper triple clamp.
Position bleeder screws
B01215-11
p. 56)
(
p. 82)
x
p. 92)
p. 131)
and O-ring
.
2
3
but do not tighten yet.
4
toward the front.
5
p. 90)
p. 55)
p. 46)
is correctly positioned.
1
53