Loosening The Fork Protection; Positioning The Fork Protection; Removing The Fork Legs; Installing The Fork Legs - KTM 250 EXC EU Repair Manual

6 FORK, TRIPLE CLAMP
6.1.6

Loosening the fork protection

6.1.7

Positioning the fork protection

6.1.8

Removing the fork legs

6.1.9

Installing the fork legs

–
Remove screws
–
Remove screws
–
Remove the screws on the right fork leg. Push the fork protection downwards.
B01515-10
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line. Position the clamp and mount and tighten screws
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
B01515-11
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel. (
–
Remove the headlight mask with the headlight. (
Main work
–
Remove screws
–
Remove cable binder
–
Remove screws
–
Hang the brake caliper and the brake line loosely to the side.
B00798-10
–
Loosen screws
–
Loosen screws
602711-11
Main work
–
Position the fork legs.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
602753-10
and take off the clamp.
1
on the left fork leg. Push the fork protection downwards.
2
p. 93)
and take off the clamp.
1
.
2
and take off the brake caliper.
3
. Remove the fork leg on the left.
4
. Remove the fork leg on the right.
5
toward the front.
1
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 10)
p. 89)
14
.
1
.
2