Removing The Engine Guard (Exc Six Days); Installing The Engine Guard (Exc Six Days) - KTM 125 EXC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.49

Removing the engine guard (EXC SIX DAYS)

11.50

Installing the engine guard (EXC SIX DAYS)

–
Inject the liquid into the system until it escapes from hole
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level under top edge of con-
tainer
B00042-10
–
Position the cover with the membrane. Mount and tighten the screws.
–
Turn quick release
guard.
B01204-10
–
Attach the engine guard at the back of the frame and swing it up at front.
–
Turn quick release
B01205-10
4 mm (0.16 in)
counterclockwise until it disengages. Remove the engine
1
all the way clockwise.
1
72
of the master
6