Checking The Rubber Grip; Additionally Securing The Rubber Grip; Adjusting The Basic Position Of The Clutch Lever - KTM 125 EXC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.44

Checking the rubber grip

11.45

Additionally securing the rubber grip

11.46

Adjusting the basic position of the clutch lever

(All 250/300 models)
–
Check the routing of the throttle cable.
The throttle cable must be routed behind the handlebar, on the right of the
upper frame tube, and to the carburetor.
» If the throttle cable is not routed as specified:
–
B01151-01
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
–
Check the rubber grips on the handlebar for damage and wear and to ensure they
are firmly seated.
» If a rubber grip is damaged, worn, or loose:
–
Change and secure the rubber grip.
Rubber grip adhesive (00062030051) (
401197-01
Preparatory work
–
Check the rubber grip. (
Main work
–
Secure the rubber grip at two points using the securing wire.
Securing wire (54812016000)
Wire twister forceps (U6907854)
The twisted wire ends face away from the hands and are bent toward the rub-
ber grip.
401198-01
(All 125/200 models)
–
Adjust the basic setting of the clutch lever to your hand size by turning adjust-
ing screw
B01152-10
Correct the routing of the throttle cable.
( p. 62)
x
p. 58)
p. 69)
.
1
p. 132)
69