Removing The Fork Protector - KTM 125 EXC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.9

Removing the fork protector

(EXC SIX DAYS)
–
Position the fork legs.
B01215-10
(EXC EU/AUS, XC‑W)
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
B00799-11
(EXC SIX DAYS)
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
B01214-11
–
Position the brake caliper and mount and tighten screws
Guideline
Screw, front brake caliper
–
Mount cable binder
–
Position the brake line and wiring harness. Put the clamp on and mount and
tighten screws
B00798-11
Finishing work
–
Install the front wheel.
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the headlight mask with the headlight. (
–
Remove the fork legs.
Info
The rebound damping is located in the right fork leg (red adjusting
screw). The compression damping is located in the left fork leg (white
adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
Position bleeder screws toward the front.
1
.
2
.
3
.
2
.
3
M8
.
5
.
6
( p. 82)
x
p. 92)
( p. 82)
x
( p. 48)
x
M8 20 Nm
(14.8 lbf ft)
M8 15 Nm
(11.1 lbf ft)
M8 17 Nm
(12.5 lbf ft)
M8 12 Nm
(8.9 lbf ft)
.
4
25 Nm Loctite ®
(18.4 lbf ft)
p. 90)
p. 46)
p. 90)
49
243™