14
ELECTRICAL SYSTEM
14.8
Changing the turn signal bulb (All EXC models)
Note
Damage to reflector Reduced luminance.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Main work
–
Turn rubber cap
the way and remove it.
–
Pull lamp socket
100861-10
–
Press headlight bulb
pull it out.
–
Insert the new headlight bulb.
Headlight (S2 / socket BA20d) (
–
Insert the rubber cap with the lamp socket into the reflector and turn it clockwise
all the way.
Info
Ensure that the O-ring
100862-10
–
Insert the lamp socket of the parking light into the reflector.
Finishing work
–
Refit the headlight mask with the headlight. (
–
Check the headlight setting. (
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove turn signal glass
–
Lightly squeeze orange cap
–
Press the turn signal bulb carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (R10W / socket BA15s) (
–
Mount the orange cap.
–
Position the turn signal glass.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
101722-10
Finishing work
–
Check that the turn signal system is functioning properly.
together with the underlying lamp socket counterclockwise all
1
of the parking light out of the reflector.
2
lightly into the lamp socket, turn it counterclockwise and
3
p. 117)
is seated properly.
4
p. 92)
.
1
in the area of the holding lugs and take it off.
2
p. 117)
p. 90)
91